Common Ink Stamps

Are you looking for images of common ink stamps for your Cobra Jet Mustang? This page exists to provide copies of images that you can use to create your own stamps. The collection is rather small right now, so please feel free to provide images that you've found useful in your restoration. Please don't ask if I have any other images -- what you see here is all I have right now.

Note that the size of the image might be a little bit different when you print it. I've listed the resolution of each image in dots per inch (dpi) to help you figure out how it might be different, but a lot depends on your computer operating system and web browser. Common display resolutions include 73dpi and 96dpi. The printed image should be the right size.

OK

Valve cover "OK" stamp image provided by Allen Cross, 75dpi.
Print size is 1.213" x 1.0".

Valve cover stamping was typically done in flat yellow paint on the front face of the driver's side valve cover.

Rev Limiter

1970 rev limiter provided by Scott Hollenbeck, 96dpi.
Print size is 1.854" x 1.0".

Rev limiter stamping was typically done in flat black paint on the front cover of the limiter.

Snorkel -A

-A Snorkel provided by Scott Hollenbeck, 600dpi.
Print size is 1.713" x 0.483".

Snorkel -B

-B Snorkel provided by Scott Hollenbeck, 600dpi.
Print size is 1.713" x 0.483".

Snorkel stamping was typically done in flat white paint on the underside of the snorkel.

Water Pump Pulley C8AE-C

Water Pump Pulley C8AE-C provided by Scott Hollenbeck, 600dpi.
Print size is 1.2" x 0.2".

Water Pump Pulley C8OE-A provided by Scott Hollenbeck, 600dpi.
Print size is 1.2" x 0.2".

Water pump pulley stamping was typically done on the front face of the pulley in flat yellow paint.